Condair CP3 Mini with Fan. CP3-PR Series with inbuilt fan for direct room applications, kg/hr. The ventilation FAN unit is used for direct room air. The CP3 is an electrode steam humidifier which represents the latest generation of proven electrode steam humidifiers. Using normal drinking. United Humidifiers – Offering Condair Cp3 Electrode Boiler Steam Humidifier in Mumbai, Maharashtra. Read about CAR HUMIDIFIER. Mini Humidifiers.

Author: Fenrigor Arashigore
Country: Brazil
Language: English (Spanish)
Genre: Life
Published (Last): 24 September 2014
Pages: 173
PDF File Size: 8.52 Mb
ePub File Size: 10.96 Mb
ISBN: 968-7-31738-805-7
Downloads: 69755
Price: Free* [*Free Regsitration Required]
Uploader: Dorisar

Condair CP3 Mini technical manual en rt

Off Current Relay heating voltage jammed in activated Inspect relay, replace if necessary. If the steam distribution pipes are installed on the suction side of the duct, the maximum vacuum must not exceed Pa.

Let your Condair service technician adjust the test run parameters heating voltage, Cylinder-No. Red LED lights and an error message is shown in the display. On Esc Set Cpp3 Full Off Partial Full Esc Set In the upcoming modification dialogue select the type of draining which takes place after a certain time coondair following setting in standby operation.

Steam line with fixed piping For steam lines with fixed piping, the same instructions apply to the laying of the piping as already described. Are the outlet orifices at right angles to the air flow direction?


Condair CP3 Mini low capacity steam humidifier | Steam Humidifiers

If you have questions concerning the direct room humidification, please contact your Condair supplier. Check humidity sensor signal Yreplace if necessary. Off Esc Set Integr. Is the unit correctly aligned, vertically and horizontally?

The inlet valve opens slight delay and the steam cylinder fills with water. Each switching point is defined by a weekday or weekday range, the switching point and the condsir setpoint. Safety Some maintenance work requires removal of the unit cover. An optional battery-powered humidity sensor can be located in the room and transmits a signal back to the humidifier to control output to the desired level. Are all transportation locks inside the unit removed? The following display are possible.

Inlet valve blocked or defective. No electrode current for more than 20 minutes ——— Warning W Safekeeping Please safeguard these mounting instructions in a safe place, where it can be immediately accessed.

Formic acid is indeed harmless to the skin, but it attacks the mucous membranes. Drain pipe and siphon X Inspect, clean if necessary decalcify and rinse out. View Contact Call Seller Now. Get Best Price Request a quote.

jini The above display shows the maximum number of settings available. Level Permissible filling time exceeded 20 minutes ——— Warning W Then, lead the hose into the unit through the break-through on the top side of the unit and insert it about 2 cm into the specified opening of the water cup.


Always place the unit on its back side. The humidity sensor A2 for the limitation of the supply air humidity is located in the supply air duct after the steam distribution pipe. Find your local Condair distributor. On this occasion check the following: Then, rinse the tubes well with hot tap water. The settings available depend on the selected signal source and cpp3 control type. JS is a Walter Meier group company. Forced Drain Safety chain instable ——— Warning W The Condair CP3 Mini cojdair on mains water and is ideal for both homes and offices.

If the unit has to be switched off because of a malfunction, please note the error code of the actual error message shown in the display.

Steam humidifiers | Condair – industrial humidifier specialist

Do not mount the steam humidifier directly to the ventilation duct insufficient stability. If the timer is activated, up to eight switching points events 1 – 8 with different capacity limits can be defined.

Economic live steam humidification condxir a building’s existing steam network to deliver dry steam to a duct or AHU. Permissible filling time exceeded more than 4 hours red lights Error E