ASTM A860 PDF

Posted in : Art

ASTM A/AM Direct No.: + Fax No.: + Email: [email protected] Board No.: + ASTM A Specification for fittings used in high pressure gas and oil transmission and distribution system. Manufacturer of Carbon steel WPHY 60 pipe fittings, Exporter of a comprehensive range of products like CS ASTM A elbow, Reducer, Effortless ordering and.

Author: Akigul Kill
Country: Bulgaria
Language: English (Spanish)
Genre: Spiritual
Published (Last): 6 July 2012
Pages: 490
PDF File Size: 18.81 Mb
ePub File Size: 15.34 Mb
ISBN: 223-2-84664-144-8
Downloads: 62657
Price: Free* [*Free Regsitration Required]
Uploader: Voodoobar

The requirements are not intended to give assurance against fracture propagation.

ASTM A WPHY GR 60 Pipe Fittings, Carbon steel WPHY 60 buttweld fittings Manufacturer, Exporter.

Failure to comply with the general requirements of Speci? Electrodes for the shielded metal-arc process shall be of the low-hydrogen type. JIS G Steel pipes for low temperature service.

In pallets, in plywood cases, in bulk. In addition, if requested to provide test reports, the manufacturer shall also provide the following, when applicable: Only the ultimate tensile strength need meet the minimum requirement of Table 2.

One or more of the supplementary requirements may be specified in the order.

Link to Active Adtm link will always route to the current Active version of the standard. Within the text, the SI units are shown in brackets. If used on small? The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. The weld metal shall be deposited in accordance with the quali? JIS G Carbon steel pipes for high temperature service.

  CLSI EP5 PDF

BoxArlingate Ln. Fittings formed above the transformation temperature or upon which welding is performed, shall be cooled to below the lower critical temperature prior to heat treatment.

Originally approved in Your comments are invited either for revision of this standard or for additional standards and should be addressed to ASTM International Headquarters. Cvenergy absorptionC; measured at? C These requirements a8860 intended to minimize fracture initiation.

This specification does not require hydrostatic testing. All base metal specimens shall be removed with the axis of the specimens longitudinal to the direction of primary metal?

A refers to the high yield strength of the fittings. This standard is subject to revision at any time by the responsible technical committee and must be reviewed every? No cracks shall be permitted. All fittings shall be furnished in the heat-treated condition.

The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of zstm other. In case of con? Fittings shall subsequently be heat treat edby normalizingquenchingand. ASTM International takes no position respecting the validity of any patent rights asserted in connection with any item mentioned in this standard.

  HEAD BANGERS ZANE PDF

Users of this standard are expressly advised that determination of the validity of any such patent rights, and the risk of infringement of such rights, are entirely their own responsibility. If you want to use it ,you can buy from following link: The chemical composition thus determined shall conform to Table 1. Combining values from the two systems may result in nonconformance with this specification.

A860 WPHY 65 PIPE FITTTINGS

What can I do for you? These fittings are for use in high-pressure gas and oil transmission and distribution systems. The aetm shall be performed as speci? Notch Toughness Properties 8.