ASTM A – Designation: A /A M – 01 An American National Standard Standard Practice f. This standard is issued under the constant designation a /a m; the number right away following the designation suggests the yr. according to the guidelines of ASTM E, “Standard Guide for ASTM A, “Standard Practice for Steel Casting, Austenitic Alloy.
|Published (Last):||24 August 2005|
|PDF File Size:||10.48 Mb|
|ePub File Size:||4.88 Mb|
|Price:||Free* [*Free Regsitration Required]|
Originally published as A — If the composition ratio is 1. BoxN. Methods are described for estimating ferrite content by chemical, magnetic, and metallographic means. Measurements may be made either before or after performance of the tension test.
The ferrite content may be limited by purchase order requirements or by the design construction codes governing the equipment in which the castings will be used. Methods are described for estimating ferrite content by chemical, magnetic, and metallographic means.
Standard Practice for Steel Casting, Austenitic Alloy, Estimating Ferrite Content Thereof
Click Here to join Astk and talk with other members! The possible extent of this astk is shown by the broken lines. Posting Guidelines Promoting, selling, recruiting, coursework and thesis posting is forbidden. Similar information is available in Table X1. Link to Active This link will always route to the current Active version of the standard.
Students Click Here Join Us! Because of errors in chemical analyses, the calculated ratio may differ from the actual composition ratio and, as a result, the ferrite content may be higher or lower than indicated by the central X1.
The quantity of ferrite in the structure is fundamentally a function of the chemical composition of the alloy and its thermal history. Thanks for any help Asfm Therefore, the precision of the ferrite content estimated from chemical composition depends on the accuracy of the chemical analysis procedure.
ASTM , Ferrite content (CF8M) – Metal and Metallurgy engineering – Eng-Tips
Your comments are invited either for revision of this standard or for additional standards and should be addressed to Satm Headquarters. Are you an Engineering professional?
Also, because the magnets or probes of the various measuring instruments are small, different degrees of surface roughness or surface curvature will vary the magnetic linkage with the material being measured. The gures immediately above and below on the lines U and L indicate the probable upper and lower bounds of the ferrite range that may be expected. The American Society for Testing and Materials takes no position respecting the validity of any patent rights asserted in connection with any item mentioned in this standard.
Sources of error include the following: Download Now White Paper: Because of segregation, the chemical composition, and, therefore, the ferrite content, may differ from point to point on a casting. A number in parentheses indicates the year of last reapproval. Sources of error include the following: The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other.
All measurements shall be made on material after the solution heat treatment required by the applicable product specication, or, if any subsequent solution heat treatment is employed, then after the nal solution heat treatment. The estimates of ferrite content from magnetic measurements S1 or from point counts S2or both, if ordered by the purchaser, also shall be reported.
Register astj while it’s still free!
ASTM International – Standard References for ASTM A / AM – 14
Signicance and Use 4. Users of this standard are expressly advised that determination of the validity of any such patent rights, and the risk a8800 infringement asrm such rights, are entirely their own responsibility. They shall not apply unless specied in the order, in which event the specied methods of ferrite content estimation shall be employed by the manufacturer before shipment of the castings. Current edition approved Mar. Digital Transformation may be defined in a number of different ways by analysts or enterprise software vendors.
Your comments will receive careful consideration at a meeting of the responsible technical committee, which you may attend.